PAL with telly

After re-reading Alan Pemberton’s article on PAL, I realised I’d been a right numpty in my post about recreating the effect of PAL on images.

I re-read the following:

Y = 0.299R + 0.587G + 0.114B

A light bulb went on, and I realised I’d been completely wrong in the way I was scaling my Red, Green and Blue images before combining them. This also meant that the Gaussian Blur step was not needed.

What I needed to do to with the colour channel images I made from my initial 720 x 576 images was to horizontally scale them in The GIMP by following amounts:

  • Red to 720 x 0.299 = 215 pixels
  • Green to 720 x 0.587 = 423 pixels
  • Blue to 720 x 0.114 = 82 pixels

Here’s the logo I created for my friend Greg Taylor’s company before:

Before image. Can you spot Emily Moore?

And here it is after using this revised method:

Now with PAL – click to enlarge the images

I’m sure I’ll come back to this again, but I’m finding it interesting.

5 Replies to “PAL with telly”

  1. Theoretically, these figures can also be used to simulate telly transmissions from the now-defunct (in the U.S.) NTSC system, as they used the same mathematical figures for color.

  2. In addition, the horizontal pixel rate on the 'Y' matrix differs among NTSC, PAL and SECAM. They are as follows:
    NTSC – 330 pixels
    PAL – 425 pixels
    SECAM – 465 pixels

  3. In addition, if doing simulated NTSC screencaps, the recommended width and height is 656 x 486, with the "clean" aperture being 648 and four "blank" horizontal pixels on each edge (eight total). Of course, for DVD's and DV's the top and bottom are shaved off to 480, but still . . . 486 is "D1" standard.

Leave a Reply to wbhist Cancel reply

Your email address will not be published. Required fields are marked *